ACCESSORIES

Continuous accurate control, water metering and direct display of current condition
in % Relative Humidity

Control of incubator humidity is the no.1 cause of confusion and misunderstanding in incubation procedure,
frequently resulting in poor hatching rates.

The solution to the problem is one of Brinsea's digital humidity management modules incubator humidifiers.

ADVANCE Humidity Pump $149.00 BUY NOW


Specifically designed to work seamlessly with the new Octagon 20 ADVANCE digital incubator (and only the Octagon 20 ADVANCE), this humidity pump includes a peristaltic pump and an external water reservoir which eliminates the chances of water in the incubator harboring bacteria.

The unit stands beside the incubator, and is connected to it by an electrical lead and a flexible tube for water supply.

Humidity settings are controlled directly from the incubator intuitive digital menu and
the achieved relative Humidity (RH) is continuously shown on the incubator’s digital display. The Octagon 20 ADVANCE incubator coupled with the Humidity Pump effectively maintains the humidity level precisely at the level the user sets irrespective of changes in room humidity and so overcomes problems that can commonly lead to eggs failing to hatch – especially in the latest stages of incubation.

The Humidity Pump module can be purchased as part of the Octagon 20 Advance EX model or separately as an upgrade from Octagon 20 Advance to the Octagon 20 Advance EX.

H22/H222 Humidity Management Modules

- H22 $369.00 - BUY NOW
- H222 $599.00 - BUY NOW

The module suits most fan-assisted incubators (not compatible with the new Octagon 20 ADVANCE) and provides continuous, direct and highly accurate relative humidity (% RH) readout. It also controls the amount of water evaporated within the incubator to maintain the humidity level set by the user.

The H22 Humidity Management Module features a digital display which clearly and continuously shows the Relative Humidity (RH) within the incubator, allowing you to both accurately monitor and if necessary adjust the humidity level in forced draught incubators as required, in order to help ensure maximum hatching success.

The Humidity Management Module will compensate for fluctuations in ambient humidity level, day or night, and allows the user complete control over incubation environment.

The unit stands beside the incubator, and is connected to it by a thin electrical lead and a flexible tube for water supply. The sensor mounts through a 25mm (one inch) diameter hole in the incubator wall, pre-cut on all Brinsea forced draft incubators. The H22 is suitable for many incubator brands holding up to about 1000 eggs.

For larger incubators, the H222 provides the same facilities but with a larger pumping capacity, suitable for incubators up to about 10,000 eggs.

MORE INFO / TECHNICAL NOTES